asterisk.ru

Вопрос такой
Установил asterisk 1.8
далее dahdi
по статье http://voxlink.ru/kb/voip-devices-confi ... vox-dahdi/
плата не видит модули fxs и fxo

01:01.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface
Subsystem: Device 9500:0003
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 96 (250ns min, 32000ns max)
Interrupt: pin A routed to IRQ 19
Region 0: I/O ports at a000
Region 1: Memory at e1001000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=55mA PME(D0+,D1-,D2+,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: netjet
Kernel modules: opvxa1200, hisax, netjet

dahdi_hardware
driver should be 'opvxa1200' but is actually 'netjet'
pci:0000:01:01.0 opvxa1200+ e159:0001 OpenVox A800P


service dahdi start
Loading DAHDI hardware modules:
opvxa1200: [ OK ]

driver should be 'opvxa1200' but is actually 'netjet'
Running dahdi_cfg: [ OK ]

dahdi_cfg -vvvvvvvv
DAHDI Tools Version - 2.6.1

DAHDI Version: 2.6.1
Echo Canceller(s): HWEC
Configuration
======================


Channel map:


0 channels to configure.

делаю
dahdi_genconf
Empty configuration -- no spans
Empty configuration -- no spans

Почему не видит модули? Подскажите плиз

сходите сюда
http://wiki.openvox.cn/index.php/Main_Page

Ключевую фразу - driver should be 'opvxa1200' but is actually 'netjet' забить в Гугль, получить результат и выполнить.

DAHDI Version: 2.6.1

ded, да.. поколение FreePBX очень ленивое стало.. нагуглил

please disable the modules(hisax, netjet). these will be conflict with analog drivers, if you get in the system,

Заработало.


Module opvxa1200 conflicts with hisax and netjet, so we've to blacklist them in /etc/modprobe.d/blacklist.conf, add following code:

Code:
# disable kernel load modules which conflicts with opvxa1200 analog card driver
blacklist hisax
blacklist netjet
then unload the module in memory:
Code:
sudo rmmod hisax
sudo rmmod netjet
restart dahdi:
Code:
sudo /etc/init.d/dahdi restart

Всем спасибо!!!!